Mobotix D24M-Sec User Manual Page 134

  • Download
  • Add to my manuals
  • Print
  • Page
    / 148
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 133
134/148
D24M User Manual: OPERATING THE CAMERA
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
3.8 Additional Notes
3.8.1 Weatherproof Qualities
The MOBOTIX D24M IT/Secure models have been certified weatherproof according to IP65
(absolutely dust-proof and resistant to water jets) and can also be wall-mounted outdoors.
The MOBOTIX D24M Basic has attained a protection class of IP54.
3.8.2 Password For The Administration Menu
Accessing the administration menu of the camera (Admin Menu button) is only possible
after entering a user name and password.
Factory default user name is admin
Factory default password is meinsm
The Quick Installation assistant automatically appears when the administration menu is
accessed for the first time. It provides an easy method to adjust the basic camera set-
tings to the current application scenario. For security reasons, it is highly recommended to
change the default administrator password after the camera has been properly configured.
Enter the user name and password exactly as shown above. Note that all entries are
case-sensitive.
Caution
Make sure that you store information on user names and passwords in a secure
place. If you lose the administrator password and cannot access the Administration
menu, the password can only be reset at the factory. This service is subject to a
service charge!
3.8.3 Starting The Camera With The Factory IP Address
If the camera's IP address is not known, you can start the camera with its factory IP
address. Section 3.2.6
Starting the Camera with the Factory IP Address
describes this
procedure in more detail.
3.8.4 Reset The Camera To Factory Settings
All settings of the MOBOTIX camera can be permanently reset to the factory default settings.
This makes sense if, for example, you have obtained a camera without any information
or you would like to reset all settings after testing the camera. In order to perform this
procedure, you need to have access to the administration area of the camera (admins
group). Open Admin Menu > Reset to reset the camera to factory defaults.
Page view 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 147 148

Comments to this Manuals

No comments