Mobotix D24M-Sec User Manual download pdf (Page 88)

88/148

D24M Camera Manual: INSTALLATION

www.mobotix.com • [email protected]

2.10.4 Mounting To A Wall Or Building Corner

Use the supplied screw anchors, screws and washers to ax the Corner and Pole Mount

to a building corner.

• Mark the four screw anchor holes on the corner of the

building, ensuring that the arrows on the mount point

upwards. Drill the holes with a 10 mm wall drill.

•

Pass the on-site network cable through one of the large

round holes at the back of the Corner and Pole Mount,

then through one of the 16mm diameter holes on the

front of the mount. In order to properly protect the cabling,

you should let the cabling run from the inside of the

building through the Corner and Pole Mount directly

into the camera (concealed cabling). Note: The cable

length from the building corner should be at least

80cm!

• Place the included wall anchors in the drilled holes

and screw the Corner and Pole Mount into place on

the corner of the building using the Torx screws and

washers. Use the supplied drilling template (fold-out

at the end of this manual) to mark the exact positions

for the drill holes.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 147 148

No comments

Mobotix D24M-Sec User Manual Page 88