Mobotix T24S Technical Information download pdf (Page 59)

100

59/98

Managing Transponders

www.mobotix.com • [email protected]

Assign contact– method 2 (with contact number): If you have speciﬁed a contact

number, enter it now and press the blue bell button. This sets up a new doorbell with

a voice mailbox that can be checked with the user card by holding it up to the keypad.

Assign contact– method 3 (with additional bell button module): If you are using

an additional bell button module (such as from the Siedle Vario range), press the

bell button that you wish to assign to the new user card as a contact.

7. Assign individual personal number: If you have speciﬁed a personal number,

enter it now and press the OK/MENU button. If not, skip this step and the card

will automatically be assigned a new personal number.

Assign individual transponder number: If you have speciﬁed a transponder number*,

enter it now and press the ESC/ALARM button until you hear the second beep.

If not, skip this step and the card will automatically be assigned a new transponder

number.

9. Present card: Hold the user card up to the keypad buttons until a beep sounds and

the keypad shows a ﬂashing ring pattern. Make sure that the card does not touch

and inadvertently trigger any of the buttons.

10. As soon as the ﬂashing pattern stops, setup for the new user card is ﬁnished. You

are now back in conﬁguration mode (the OK/MENU button lights up blue). Press

the ESC/ALARM button to exit. After 60 seconds, the mode is exited automatically.

Note

In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay

of more than 60 seconds, a low warning tone is sounded and the system reverts to

the regular operating mode (all buttons light up white). If required, re-enter into Add

mode as described above.

0 9

Person No.

MOBOTIX recommends

setting up all the

cards and access PINs

associated with one

person to share the

same personal number

0 9

Transponder No.

ESC

hold (2nd beep)

* For example, the last

digits of the imprinted

card serial no.

ESC

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 99 100

Comments to this Manuals

No comments

Mobotix T24S Technical Information Page 59

Comments to this Manuals