Mobotix D14D Service Manual download pdf (Page 77)

77/132

Network And Power Connection

www.mobotix.com • [email protected]

The MOBOTIX factory default is PoE class 2. This default is usually ﬁne and nothing needs

to be changed. However, the PoE power class must be changed in the browser if the

higher power class 3 is required for your application:

1. Select Admin Menu > Network Setup > Ethernet interface

(for experts).

2. Under Power Supply, click on Change.

3. A Power Wizard will appear to guide you through the PoE

conﬁguration steps.

4. Next, restart the camera: Disconnect the camera from the

power supply. Then reconnect it, for example, by disconnecting

and then reconnecting the Ethernet cable at

the PoE switch.

2.7.3 Power Supply Using A Switch

1. Connect the factory pre-installed cable of the

camera to the Camera connector of the PoE

adapter.

2. Connect the LAN/Power connector of the

PoE adapter to the Ethernet connector of the switch/router or the Ethernet socket.

3. Plug the RJ45 connector of the power supply unit into the PC/Power connector of

the PoE adapter.

Variable PoE: multiple

cameras can be operated

simultaneously from

the same switch

For the D14D,

you should use the blue

MX-NPA-PoE Set –

previous MOBOTIX

network power

accessories such as the

NPA Set, Power Box,

and Power Rack

(MX-NPA-Set,

MX-NPR-4 and

MX-NPR8/20) are

not suitable for use

with the D14D

The IP addresses in

the diagram are shown

only as an example

Switch/router

PoE Adapter

(MX-NPA-PoE)

Power supply

LAN/www

(10.8.0.11/255.0.0.0)

Camera

(10.8.0.99)

LAN/Power

PC/Power

Camera

RJ45

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 133 134

Comments to this Manuals

No comments

Mobotix D14D Service Manual Page 77

Comments to this Manuals

Related products and manuals for Security cameras Mobotix D14D