Mobotix D22 User Manual download pdf (Page 81)

3.3.2 Camera Startup Sequence

As soon as the power supply is established, the camera's LEDs will provide infor-

mation on the startup sequence of the camera.

• Booting: Immediately after connecting the power supply, the red LED lights

up, blinks for two seconds, then stays on permanently. The camera's boot

loader checks the hardware, unpacks and starts the operating system. All

applications are verified using the checksums; in case of an error, the cam-

era will start using the backup operating system.

• Waiting for key pressed: Both LEDs light up for four seconds. If you press the

"R" or "L" key of the camera during this time, the camera will execute the

corresponding function (see sections 3.5 and 3.6).

• Ready: Once the application software has been started, the green LED is on

permanently and the red LED blinks. You can now reach the camera via the

network using a browser. For additional information on this topic, see section

5.4.3,

LED Signals and LED Configuration

, in the

Software Manual

www.mobotix.com • [email protected]

79/104

D22M Camera Manual Part 1

Start!

Key pressed?

Ready

Note

During the startup sequence of the camera, the LEDs will always light

up, even if they have been deactivated in Admin Menu> LED Setup.

LEDs (1 x green, 1 x red)

"R" key "L" key

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 112 113

No comments

Mobotix D22 User Manual Page 81