Mobotix M15 Specifications download pdf (Page 115)

115/148

Adjusting Camera, Lens Focus and Installing Filters

www.mobotix.com • [email protected]

3.3.4 Replacing the Dome Against the Sealing Ring (Only Sensor Modules

L10-L12)

For special scenarios with hemispheric sensor modules,

e.g., if light entering from the side creates reﬂections within

the dome, you can use the sealing ring instead of the

dome (order no. MX-OPT-Ring-L10-L12).

To exchange the dome against the sealing ring, use the

blue lens wrench supplied with the S15D basic module.

Caution

In order to avoid burns by the hot lens, the sealing ring must not be installed if

the sensor module is within the reach of persons!

Procedure

1. Insert the blue lens wrench into the notches of the

dome. Rotate the wrench to the left until you feel

a stop (max. 300°) and then a little bit further until

the dome slides out of the sensor module. When

doing this, make sure that the dome does not get

stuck in the sensor module housing.

Turn the wrench over, insert the two notches into the

slots of the lens’ metal ring and unscrew the lens

until you can remove it from the sensor module.

3. Insert the lens into the sealing ring as shown.

4. Fully insert the lens into the sealing by pressing

ﬁrmly on two sides of the lens, until the metal rim

of the lens is on the same level as the sealing.

M.7

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 147 148

No comments

Mobotix M15 Specifications Page 115