Mobotix MX-KEYPAD1-EXT-SV Technical Information download pdf (Page 109)

109/148

Installing The Indoor Unit T24-Info2wire+

www.mobotix.com • [email protected]

2.6.3 Installation Using Cavity Or In-Wall Socket

1. Prepare the cavity or in-wall socket: see Section 2.5.3

2. Screw the two-wire cable to terminals 1 and 2: The

cable does not necessarily need to be attached to the

terminal with the same number on both T24-Info2wire+

units. The device continues to function if connectors 1

and 2 are swapped.

Connectors 3 and 4 are only assigned if an external

voltage source (48-57 V DC) is used.

3. Remove the front panel and frame: In order to

protect the circuit board, the board is attached to

the front panel and frame in the original packaging.

To continue with the installation, however, you must

ﬁrst separate the housing and board from the panel

and frame. Loosen the screw in the front panel and

lift the panel forwards.

Now remove the attached frame from the circuit

board. Please note that you will need the stainless

steel screw in the front panel again later.

Safety Warning

Use this product in compliance with the applicable legal regulations. Electrical systems

and equipment may only be set up, changed and maintained by a qualiﬁed electrician

or under the management and supervision of a qualiﬁed electrician in accordance with

electrotechnical regulations.

4 3 2 1

85$ 21#$- ;"$2

'"+ '$$; +" /$ #$)"7$;

1")><$+$<4 (#")

+5$ (#"'+ >*'$<

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 149 150

No comments

Mobotix MX-KEYPAD1-EXT-SV Technical Information Page 109