Mobotix D22 User Manual download pdf (Page 56)

• Release the internal part of the camera by

turning the ring inside in counter-clockwise

direction using the supplied toothed wrench.

While doing so, hold the camera at the lens

unit to prevent it from turning.

• Disengage the internal part of the camera

with the lens unit from the base of the hous-

ing.

• Position the base of the camera housing over

the drilled holes and the prepared cable exit

in the ceiling. If the holes in the base of the

housing are closed, push through the holes

using a suitable tool or use a suitable drill bit

to open the holes. Caution: These holes will

need to stay closed on D22M-IT/Secure

models.

Make sure that the cable is at least 15cm (6in) long within the camera hous-

ing (excluding the connector itself), as in the factory-installed cable.

It is very important that the rubber plug of the network cable reliably

protects the housing from moisture entering the camera. This will ensure

that the camera remains weatherproof.

• Use the delivered screws to mount the base

of the camera to the ceiling.

If the cabling from the ceiling is not directly

beneath the camera, make sure that the net-

work cable is not damaged by one of the feet

of the camera base. When tightening the

screws of the camera base, the base will lock

the cable in place, thus securing the cable

against the ceiling. The cable is now firmly

installed and cannot be pulled out or reposi-

tioned.

www.mobotix.com • [email protected]

54/108

D22M Camera Manual Part 1

Maximum torque for all

screws is 1 to 1.2Nm

(0.74lbf ft)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 112 113

No comments

Mobotix D22 User Manual Page 56