Mobotix D22 User Manual download pdf (Page 58)

2.5.3 Finishing the Mounting Process

Establishing a Connection to the Camera

• Establish a connection to the camera as described in section 3.4,

Establish-

ing a Connection to the Camera

Adjusting the Lens, Visual Check

Make sure that you see the live image of the camera on the monitor of your com-

puter or laptop. Now adjust the lens until you see the desired image area on your

monitor.

• Remove the camera dome. Take the deliv-

ered plastic foil or a cotton cloth and remove

the dome by turning it in counter-clockwise

direction. Make sure that you remove the

camera's outer shell on IT/Secure models

before you attempt to do this.

• Slightly loosen the toothed ring inside by

turning it in counter-clockwise direction using

the supplied toothed wrench. Also slightly

loosen the two Allen screws at both sides

of the lens unit by turning them in counter-

clockwise direction using the supplied Allen

wrench.

Loosen the outer shell and the Allen screws

only slightly, so that you can turn the internal

part of the camera and tilt the lens unit with-

out using excessive force. The internal part

and the lens unit should not reposition them-

selves.

• Fine-tune the image area that is displayed

on a computer monitor by turning and tilting

the lens unit accordingly. Never use force

when adjusting the direction of the camera,

as this could damage the camera beyond

repair. The internal part of the camera with

the lens unit should turn and tilt easily, but it

should not reposition itself.

www.mobotix.com • [email protected]

56/108

D22M Camera Manual Part 1

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 112 113

No comments

Mobotix D22 User Manual Page 58