Mobotix D24M-Sec User Manual download pdf (Page 78)

78/148

D24M Camera Manual: INSTALLATION

www.mobotix.com • [email protected]

2.9 Installing The Wall Mount

2.9.1 Mounting Instructions

The Wall Mount allows you to easily mount D24M cameras to walls or extensions, both

indoors or outdoors. The camera remains IP65 weatherproof (dust-proof and resistant

to water jets). The Wall Mount also covers RJ45 ﬂush-mounted sockets and has ample

space for additional modules (Mx2wire, WLAN, batteries, etc.).

Before mounting the MOBOTIX D24M with the Wall Mount, you must prepare the network

connection and drill the holes for the ﬁxtures:

•

The on-site network cabling is passed through the opening

in the back of the Wall Mount. The cable and the required

(standard) connector for the camera cable (patch cable) are

ideally protected by a robust wall sealing made from foam

rubber. Nothing is visible or accessible from the outside. The

Wall Mount may be mounted directly on top of surface- or

ﬂush-mounted sockets. Maximum width x height of the

socket: 88 mm x 80 mm.

• Only use the factory installed patch cable of the D24M (50 cm cable length) or a

MOBOTIX cable that is available as an accessory in various lengths.

• All openings of the camera housing need to be properly sealed. This is the only way

to guarantee that the camera remains weatherproof.

• The supplied screw anchors should be used for the drill holes in the wall. Use the

drilling template for the D24M Wall Mount (fold-out at the end of this manual) to

mark the exact position for the drill holes and the holes through which the cables

will later be fed.

Direct installation over

surface- and ush-

mounted sockets

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 147 148

No comments

Mobotix D24M-Sec User Manual Page 78