Mobotix D24M-Sec User Manual download pdf (Page 64)

64/148

D24M Camera Manual: INSTALLATION

www.mobotix.com • [email protected]

2.6.3 Procedure

1. Attach washers: Prior to installation, stick a black foam

rubber washer around each of the four screw holes on

the rear side of the on-wall housing (remove the adhesive

foil and press into place, surface must be clean and free

of grease). This prevents water from entering the housing.

2. Prepare the cabling: Insert the seal into the cable

opening of the On-Wall Set such that the black rubber

seal is on the outside. Fix it in place from the inside

using a small hexagonal nut.

3. Mount the On-Wall Set: Mount the On-Wall Set (with-

out the camera) at the intended position using the Torx

screws (included with D24M camera, items 1.10 – 1.12).

4. Cable feeding: Attach the counter nut to the network

cable, pass it through the seal from the outside and

tighten the nut. The network cable is now screwed into

the On-Wall Set, weatherproof. All unused openings

must be sealed with the included sealant plugs. The

cable passing into the housing must always be installed

using the supplied three-part ﬁttings.

Remove the camera outer shell: Remove all four Allen

screws with the supplied Allen wrench and lift o the

outer shell (not mounted upon delivery).

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 147 148

No comments

Mobotix D24M-Sec User Manual Page 64