remainder of the image.
Values: Total .. 0% .. 100%
The factory default setting is Total which means that the entire
image is used for white balance.
Average Brightness Using this parameter, you can influence the average brightness
within the exposure fields. Note, that too high a value may affect
the exposure time.
The factory default setting is 40%.
Show Field on: Shows exposure field(s) as green box(es).
The other options (Histo Raw Inside, Histo Raw Outside, ...) show
additional histograms with parameters of specific image processing
features.
Max. Exposure Time Set the maximum exposure time in seconds.
Min. Exposure Time Set the minimum exposure time in seconds.
Exposure Correction Use this parameter to increase/decrease the exposure time by up
to two steps.
Frequency of Power
Supply
This parameter sets the camera to the power supply frequency of
the respective country to prevent interference.
The factory default setting for Europe is 50 Hz. For Canada, the
U.S.A. and Japan, set the power supply frequency to 60 Hz.
Note: In the lower part of the dialog, the current exposure settings of the image sensors are
displayed.
42.2 Storing the Configuration
Click on the Set button to activate your settings and to save them until the camera is rebooted.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire
configuration for changes. If changes are detected, you will be asked if you would like to store the entire
configuration permanently.
42 Exposure Settings 111
Comments to this Manuals