Mobotix D24M-Sec User Manual download pdf (Page 95)

95/148

D24M Camera Manual: INSTALLATION

www.mobotix.com • [email protected]

The MOBOTIX factory default is Class 2. This default is usually ﬁne and nothing needs

to be changed. However, if the lower power level Class 1 is sucient for your application,

it may be advantageous – due to possible internal power distribution schemes amongst

the ports of the PoE switch in use – to change the PoE power level class in the browser:

1. Select Admin Menu > Network Setup > Ethernet interface

(for experts).

2. Under Power Supply, click Change.

3. A Power Wizard will appear to guide you through the PoE

conﬁguration steps.

4. The camera will then need to be restarted via a hard reboot:

Disconnect the camera from the power supply, then recon-

nect it, for example, by disconnecting and then reconnecting

the network cable at the PoE switch.

2.13.3 Power Supply Using A Switch

1. Connect the factory pre-installed cable of the

camera to the Camera connector of the Network Power Adapter.

2. Connect the LAN/Power connector of the NPA to the switch/router or the Ethernet

socket using an Ethernet connector.

3. Plug the RJ45 connector of the external power unit into the PC/Power connector

of the Network Power Adapter.

Variable PoE: multiple

cameras can be oper-

ated simultaneously

from the same switch

For the D24M, you

should use the new

blue MX-NPA-PoE-Set

- previous MOBOTIX

network power acces-

sories such as the NPA

Set, Power Box and

Power Rack (MX-NPA-

Set, MX-NPR-4 and

MX-NPR8/20) are

not suitable for use

with the D24M

The IP addresses in

the diagram are shown

only as an example

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 147 148

No comments

Mobotix D24M-Sec User Manual Page 95