Mobotix D12 Technical Information Page 75

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 74
3.3.7 Camera Startup Sequence
As soon as the camera's power supply has been established, the six LEDs will
show the progress of the starting sequence:
Hardware test: After the power has been connected, the LEDs 1 and 5 will
light up for about two seconds. The camera's computer (boot loader) checks
the camera hardware. At this time, the camera also provides a method for
booting with the factory IP address by holding the magnetic side of the cus-
tom tool on the spot labeled "L" button in the figure. See 3.5,
Starting the
Camera Using the Factory IP Address
, for more information.
Backup system test: The camera checks the operating system. In case of
an error, the camera will start using the backup operating system, allowing
you to re-install the system software.
Unpacking the OS: The boot loader unpacks the operating system from the
Flash EPROM and copies it to the camera's memory (the LEDs 1 and 5 light up
for about 10 seconds).
Starting the OS: The Linux operating system unpacks its data to the ramdisk
and initializes the system. All operating system components are verified
against their checksums in order to detect changes.
Boot mode: As soon as LEDs 5 and 0 light up, you can start the camera
using DHCP by holding the magnetic side of the custom tool onto the spot
labeled "L" button in the figure. See section 3.6,
Starting the Camera With
an Automatic IP Address (DHCP)
for more information.
Starting the applications: Once the application software is running, the LEDs
1 and 5 will start blinking (provided they have not been switched off for this
configuration). You can now access the camera using a web browser.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected] • 23.11.2006
73/96
D12 Camera Manual Part 1
Hardware Test
Backup System
Test
Unpacking/
Starting OS
Boot mode
Ready
Signals of the camera
LEDs:
0 On
1 Camera
2 Network
5 Camera
Note
During the startup sequence, the LEDs will always light up, even if they
have been deactivated in Admin Menu> LED Setup.
Page view 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 99 100

Comments to this Manuals

No comments