Mobotix D12 Technical Information download pdf (Page 86)

100

3.5 Starten der Kamera mit automatischer IP-Adresse (DHCP)

If your network has a DHCP server, you can start the camera with DHCP support to

automatically obtain a dynamic IP address.

In order to start the camera using DHCP, hold the magnetic side of the supplied

custom tool onto the spot on the camera casing containing the L button (the mag-

netic switch is mounted inside the camera casing):

• Disengage the outer shell using the supplied

custom tool (see section 2.10,

Disassembling

and Assembling the Camera

• If the camera was powered on, disconnect

the power supply of the camera by unplug-

ging the corresponding cable.

• Connect the camera's power supply.

• Wait until LEDs 5 and 0 are lighting up per-

manently.

• Now hold the magnetic side of the custom

tool onto the spot labeled "L" button in the figure.

• Only remove the custom tool when the camera plays a sound ("Boing,

Boing").

As soon as startup has been completed, the camera automatically announces its

IP address, its network mask and its MAC address (if the loudspeaker has not been

deactivated).

You can now access the camera using the IP address it just announced.

www.mobotix.com • [email protected] • 23.11.2006

84/96

D12 Camera Manual Part 1

Make sure that the

loudspeaker is activated!

Announce IP address:

hold magnetic side of

custom toolto "L" button

In case of an error, the

camera uses its last IP

address

Note

If you would like to have a running camera repeat its network settings,

simply activate the L button once using the magnetic side of the

custom tool.

Caution

When starting the camera with DHCP support, make sure that the

DHCP server is running properly. If this is not the case, the camera

cannot obtain a valid IP address and will fall back to its last IP address.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Comments to this Manuals

No comments

Mobotix D12 Technical Information Page 86

Comments to this Manuals