2.6.3 Connecting the CAT5 Cables
If the MOBOTIX D12D-Outdoor should use a network (Ethernet) and an ISDN
connection, make sure to install a second CAT5 cable (min. 50cm for D12 only,
70cm for D12 with outdoor wall mount) and to guide it to the camera casing. In
order to prevent confusing this cable with the pre-installed network cable, this
cable should have a different color (e.g. green as in the figure) and it should be
clearly marked as ISDN cable.
• Remove the M4x25 Allen screws of the cable cover (item7) using the sup-
plied 3mm Allen wrench and lift the cover out of its seat.
Note: If the cable cover cannot be removed
by hand, take a screwdriver to lift it out of its
seat. Insert the screwdriver into the grooves
shown below and
gently lift the cable
cover.
• Lead the CAT5 cable from the bottom of the camera casing through the right-
hand opening and guide it around the camera casing in counter-clockwise
direction (as seen from above). Make sure that this cable is running properly
as shown in the figures below.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
42/96
D12 Camera Manual Part 1
3 mm Allen wrench is
included in the delivery
Lead the cables through
the cable guides at the
outer rim of the casing
Comments to this Manuals