2.10 Assembling and Disassembling the Camera
2.10.1 Assembling the Camera (Detailed Description)
For adjusting the D12, you need the supplied Allen wrench; for attaching the dome,
a lint-free cotton cloth is required (see also section 2.9,
Cleaning Instructions
).
(1) Inserting the lens units and fixing the central lens screw
Insert the lens units into the seating. Insert the
central lens screw and gently tighten it to hold
the lens units in place.
Caution: Avoid over-tightening the screw as
this might damage the camera casing.
(2) Connecting the ribbon cable to the lens units
Insert the connectors of the ribbon cable into the pin heads of the lens units.
While doing so, make sure that the lens unit's ribbon cable connectors are
pointing upwards into the dome. This will
ensure that the lenses can be positioned
freely later on, without putting any strain on
the ribbon cables. Make sure that the ribbon
cables are running properly along the inside
of the dome's rim. The ribbon cables must not
obstruct the line of vision of the lenses!
(3) Securing the ribbon cables using the cable clamps
To do so, gently squeeze the clamps between your fingers and insert the
clamps into their seats along the inside of the dome's rim. Make sure that
the pin of each clamp is properly positioned in the corresponding hole of the
camera casing.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
55/96
D12 Camera Manual Part 1
Caution:
Make sure that the lens
ribbon cable connectors
point into the dome.
Press clamp together
cautiously, then insert
into the seats; make sure
the pin is snug in the hole!
Pin
Comments to this Manuals